Ridge Flyers Forum

I need to know if the button on the rear of the module is a BIND/Range test button.
On my Spektrum (DX7) it specifies it, but on the module and receiver (conversion) package for my JR 8103TX it does not.

When I start a range test, standing next to the heli everything works fine. When I walk away (90+ ft) and start checking controls (pressing button in) and moving sticks, it does not. At this point in time I don’t know the distance that I lose control between heli and transmitter.

Any help in understanding what is going wrong here would be great. May I have a faulty module\receiver?

That button on the back is for both binding and range testing. With the button pressed in I usually get about 75 feet back from the receiver before I notice any twitching. When I let the button up it goes to normal.Now I don't know if 75 ft. is good or bad. But when I fly everything is good.Check your manual over once again there should be a section about range checking.

Good Luck